签订合同,实地勘察施工现场情况。
signing the contract,Survey the construction site.
压印覆盖,旧有地坪
Embossed cover old floor
把表面所有油、污垢、涂料、覆盖物等移除。
Remove all surface oil, dirt, paint, cover.
用CSR(超级混凝土翻新剂)洗刷,再用清水冲洗干净。
Rinse with CSR (super concrete renovation agent) wash, then water.
用水充分湿润地坪/墙面,湿润但不积水。
Water to fully wet floor / wall, moist but not water.
铺防裂纤维网,压印系列混料包每包加2kg附牢度增强剂,加水充分搅拌均匀作界面剂,抹刮进入纤维网层约2毫米。
Shop crack webs, embossed series mixing bag plus 2kg per pack attached fastness enhancers, add water, stir for interface agents, hand scraping into the fiber network layer of about 2 mm.
充分搅拌材料最多3分钟至粘度适中状态可适当加颜料包调整底材颜色。
Stir material up to three minutes to state moderate viscosity may be appropriate to adjust substrate color pigment package.
倒料约0.8-1.25厘米厚
Pouring about 0.8-1.25 cm thick
材料干燥至不粘手,倒料后约1-2小时内可压印, 在混料表面及模具上喷上液体脱模剂,压印。
Material is dried to a sticky, imprintable within about 1-2 hours after pouring, The mixing surface and mold release agent sprayed liquid, stamping.
待材料干后用CSR洗刷液体脱模剂,再用清水冲洗,表面干净后才可上色。
After the material is dried by CSR wash liquid release agent, then rinse with water after clean surface before color.
可用新型环保色精或有色封面漆。
Available new environmentally friendly paint color fine or colored cover.
(如使用了有色封面漆就不需要该步骤)可用水性/溶剂性封面漆(最少封两道)。
(Such as the use of colored paint covers do not need this step) can be aqueous / solvent paint cover (at least two letters).